What command will list only current connections including IP addresses?

What command will list only current connections including IP addresses?

Execute the netstat command alone to show a relatively simple list of all active TCP connections which, for each one, will show the local IP address (your computer), the foreign IP address (the other computer or network device), along with their respective port numbers, as well as the TCP state.

Do IPv4 and IPv6 use the same packet format?

IP is an unreliable, connectionless protocol. IPv4 and IPv6 use the same packet format. As a network support technician, you only need to know how to support IPv6. On IPv4 networks, IGMP operates at the Network layer of the OSI model to manage multicasting.

What is the purpose of the checksum TCP field?

What is the purpose of the checksum TCP field? It allows the receiving node to determine whether the TCP segment became corrupted during transmission.

Which fields are used by IPv4 and IPv6 respectively to limit the number of times a packet can be forwarded on a network?

Known as time to live (TTL) in IPv4, and hop limit in IPv6, this field specifies a limit on the number of hops a packet is allowed before being discarded. Routers modify IP packets as they are forwarded, decrementing the respective TTL or hop limit fields.

What command will list only current connections including IP addresses and port?

netstat-n is the answer.

What is the purpose of checksum TCP field?

What is the purpose of the checksum TCP field? It allows the receiving node to determine whether the TCP segment became corrupted during transmission.

What does the MX record do in a forward DNS zone?

What does the MX record do in a forward DNS zone? It identifies the e-mail server to be used for e-mail traffic for the domain.

Does IP establish a session to send packets?

IP is an unreliable, connectionless protocol, as it does not establish a session to send its packets. IPv4 and IPv6 use the same packet format.

Can IPv6 send IP packets to IPv4?

Such a node, referred to as IPv6/IPv4 node in [RFC 1993], the ability to send and receive both IPv4 and IPv6 packets. When interoperating with an IPv4 node, an IPv6/IPv4 node can use IPv4 packets; when interoperating with an IPv6 node, it can speak IPv6. IPv6/IPv4 nodes must have both IPv6 and IPv4 addresses.

Can IPv6 send IP packets to IPv4

What IPv6 field is similar to the TTL field in IPv4 packet?

The hosts will still send and receive traffic, but traffic may not always reach the correct destination. What IPv6 field is similar to the TTL field in IPv4 packets? Routing Information Protocol (RIP) is an interior gateway protocol that uses a link-state algorithm.

How are IPv4 and IPv6 applied?

Known as time to live (TTL) in IPv4, and hop limit in IPv6, this field specifies a limit on the number of hops a packet is allowed before being discarded. Routers modify IP packets as they are forwarded, decrementing the respective TTL or hop limit fields.

Leave a Comment